Practical Use Of Rivet Nut Guns
Rivet nut gun is divided into pneumatic and manual two, with the advancement of industrialization, more factories have introduced pneumatic rivet guns, the use of tandem cylinders to complete the rivet nut, the use of the familiar principle of leverage, with the amplification of the input force to complete the riveting operation, in our traditional use of welding technology, will allow the surface of the sheet metal left welding joints, sheet metal ductility will also be poor because of welding, and Many sheet metal parts are not easily tapped. The rivet nut gun was developed based on the above problems.
The use of flat head rivet nuts and rivet nut gun to complete the fixed connection of sheet metal, the general rivet nut gun are forward and reverse two, in the use of the process we first rotate the nut into the rivet nut gun, the corresponding riveting point position, and then press the switch, the joint through the rapid rotation to complete the pull rivet; riveting process is very convenient, the use of rivet nut gun can also greatly accelerate our work efficiency.
Related Post
The characteristics of FRP pipe repair are: no need to stop work, fast leak plugging. This repairer adopts grid rubber ring, which can achieve sealing effect through the grid layer by layer pressure relief. It is very convenient to install by wrapping the leak and tightening the bolt without welding.
Hardware manufacturing methods are diverse, life everywhere can not be separated from the hardware, as small as screws, Avenue the entire mechanical system, but also a consumable, different hardware can create different effects out.
Screws are rusty, how to remove？
A small screw, everywhere in life, but everything has a service life, with the use of time, inevitably produce all kinds of problems that need attention, and the solution, some maintenance, some removal.Screw is no exception. When the screws are rusty, how do we remove them?
What are the causes of stator wear in screw pumps?
Screw pumps are generally made of steel for the rotor and rubber for the stator. And the material used to make the stator is generally nitrile rubber, the reason is that nitrile rubber has very good oil resistance. Rotor because of the use of steel so more wear-resistant than rubber, so the failure of the screw pump is destined to be mainly in the form of wear and tear of the county rubber sleeve. That is to say, the service life of the stator and the life of the screw pump is closely related, want to extend the service life of the stator to find ways to solve the problem of rubber wear.
Industrial application of pneumatic grinding machines
With the continuous promotion of industrialization,pneumatic systems have been widely used in various industries in the market, pneumatic riveting, pneumatic grinding,pneumatic assembly,etc.